Bottom Entry or Top Entry: The Cable Decision That Outlives the Project
Panel layout drawings show a rectangle, a row of breakers and a note in the corner that says cable entry from below. That note travels further than any other line on the sheet: it fixes the gland plate, the internal cable duct, the height of the DIN rail, and eventually the length of every cable pulled into the room.
Why bottom entry is the default
Floor trenches and raised floors are common in plants, and cables that arrive from below keep the top of the enclosure clear for cooling. Bottom entry also keeps water away from the gland plate when the room is washed down, provided the plate sits above the floor line and the enclosure has a drip edge. On a power distribution cabinet installed against a wall in a service corridor, bottom entry is usually the only layout that leaves the door able to open fully.
When top entry is the better answer
Cable tray suspended from the ceiling, overhead busbar, or a mezzanine feed all point to top entry. It shortens the cable run and keeps the floor free, which matters in clean rooms and packing halls where a floor trench collects dust. The cost is on the enclosure: top entry needs a rain hood or a sealed plate, and the internal duct has to route around the breaker terminals rather than through them.
The three questions to settle early
- Where is the tray or trench, measured from the wall, not from the drawing?
- How many cables today, and how many in five years?
- Is the room washed down, and does the floor slope toward the panel?
Answers to those three decide the gland plate drawing, and the gland plate drawing is what the sheet metal shop cuts. Changing direction after cutting means a new plate and on a large order of power distribution cabinets, a week of production rework.
Spare capacity is not padding
Reserve twenty to thirty percent of the plate area. Retrofit cables — a new sensor, a communication link, a second feed for a chiller — appear within the first two years on almost every panel we build. Panel space is cheap at the quotation stage and expensive in a shut-down window.